|
|
|
|
|
|
AEP4:
- 34 dB or 40dB (jumper-selectable) into 50 Ohm
- 2,5 kHz to 3.8 MHz, (to 1MHz full power 10VPP into 50 Ohm)
- +28VDC24mA (no signal) 64mA (10VPP into 50 Ohm)
- Noise: 10µVPK,1.2µVRMS
@90-850kHz
- Pulse-through calibration bypass for automated sensor coupling test
- 65 * 60 * 35 mm (BNC connector not considered) 200g
- 5°C to 105°C
|
|
|
AEP4-IS:
like AEP4, but
- Sensitivity increase: AEP4-IS delivers up to 11dB higher signal amplitude
than preamplifiers and 1.2m sensor cable, due to
the short internal cable.
- internal electronics protected by epoxy molding
- 3 strong magnets
- for sensor cases -M and -H
|
|
|
AEP4H-ISTB:
- optimized for tank floor testing
- designed for sensor VS30-V
- 46dB into 50Ohm
- Bandwidth (-3dB): 20kHz to 1MHz
- Noise (VS30-V connected): 18dBAE(<10µVPK)
@ 20-45kHz
- internal electronics protected by epoxy molding
- Power supply: 28VDC24mA (no signal) 64mA (10VPP
into 50 Ohm)
- Pulse-through calibration bypass for automated sensor coupling test
- Dimensions: H: 60mm (2.36 in.), (incl. magnets), W: 57mm (2.24 in.)
L: 65mm (2.56 in.) (+18mm/0.7 in. BNC),
- Weight: 370gr
- Temperature range: 5°C to 85°C
- Magnet hold-down force: 3x 95N
- Sensor hold-down force: 10N (spring loaded)
|
|
|
AEP3:
- Programmable by host-PC to 34, 37, 40, 43, 46, or 49 dB (can also
be defined by jumper).
- BNC coax for single ended sensors, BNO for differential sensors, used
connector selected by manual switch
- Various combinations of sharp high-pass/low-pass plug-in
filter modules available.
- Pulse-through calibration bypass for automated sensor coupling test
- 174*79*58mm
- weight 800g
- 5°C to 65°C
|
|
|
VS150-RIC,
VS375-RIC, VS900-RIC:
- Sensors with integrated preamplifiers
- rugged and handy, well suited for field testing
- BNC connector
- Pulse-through calibration bypass for automated sensor coupling test
- D 31 * H 29mm, 60g
- -40°C to +85°C
See section sensors for more details (e.g.
frequency responses). |
|
